4/11/2023 0 Comments Cateye strata cadenceWe do NOT offer a fault-free refund option on bikes. We advise customers to take as much time as they need to make sure that they buy the correct bike and we have many bikes available for test ride to help in reaching the right decision. If you decide that you are not happy with your new bike after you have picked it up or taken delivery then please contact us and we will do our best to resolve the issue. PLEASE NOTE that this does not apply to bikes and helmets. If you are unhappy with your item then we will be happy to offer an exchange or refund within 30 days of the purchase date. ALL unwanted goods must be returned with a copy of the original receipt, original packaging and in a resalable condition. This is the most accurate wheel calibration number.If you have received a product from us that is either faulty or unwanted please first contact us before returning the item. With the riders weight on the bike, roll the wheel one tire revolution in a straight line and mark the ground when the valve stem is perpendicular to the ground again. With the valve stem perpendicular to the ground, mark the pavement at the valve stem. ![]() To get the most accurate calibration do a wheel roll out. Measure wheel circumference (L) of your bike Switch the screen or move digits (by pressing & holding) When MODE is pressed and held, “Displayed time”, “Hour”, and “Minute” will appear, in this order. * Refer to the tire circumference reference table. When the computer is mounted on the bracketĮnter the tire circumference of your bicycle in mm. When attaching the bracket to the handlebarģ Nut 4 Speed sensor 5 Cadence sensor 6 Wheel magnet 7 Cadence magnet 8 Wind the cable on the rear brake cable as shown.Ĭaution: Turn the handlebar to make sure wire does not hinder full rotation. Use the nylon tie 0 to secure the cable on the frame. Install the cadence sensor and cadence magnetĬaution: Round off the cut edge of the bracket band to prevent injury.Īttach the bracket to the stem or handlebarĬaution: Tighten the bracket, ensuring that the cable does not get caught in the stem.Ĭaution: Tighten the bracket, ensuring that the cable does not get caught in the handlebar. Install the speed sensor and wheel magnet If the speed is not displayed, check that conditions Rotate the crank in the non driving direction and check cadence is displayed. ![]() In the case of the cadence sensor, press MODE to display C (cadence) on the mode screen. In the case of the speed sensor, lift the rear wheel off the ground and spin the wheel to check the speed is displayed. * After installation, check that the speed sensor and cadence sensor are functioning properly. * For wing type handlebar or oversized stem,īracket can be mounted using the Bracket Holder and nylon ties. The clearance between the sensor surface and the magnet must not exceed 3 mm. The magnet should pass through the sensor line. * When installing cadence sensor 5, insert
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |